Engine super-flush Decarboil RESURS

Engine super-flush Decarboil RESURS

Get rid of oil burn!

The main causes of oil burning:

  • 50% — blocked oil scraper rings;
  • 30% — wear of engine parts;
  • 20% other.

Decarboil RESURS is struggling with the main cause of oil burning — it frees rings and oil drainage channels from deposits. Decarbonization through the oil system.

Learn more: www.flush.smazka.ru/en

Packaging options:
100 ml
Code: 9601
5l
Code: 9601i
20l
Code: 9601ii
About
Instruction
Documents
Where to buy

Washing away deposits and varnish improves the thermal balance of the engine, which is the basis of its effectiveness and durability

Reduces oil burning up to 3 times

For deep cleaning of heavily contaminated engines, it is recommended to apply RESURS Decarboil twice, changing the oil each time after a flush cycle.

Dissolves but not peels off the deposits

This is important when cleaning heavily contaminated engines. Peeled off deposits can lead to jamming of the oil system and oil starvation.

Releases oil scraper rings and channels

Struggles with the cause of oil burn. Contamination of the rings is inevitable – the engine burns fuel, and the combustion products settle on the rings.

Related articles

First engine decarbonizing kit

First engine decarbonizing kit

Precautions

The composition may affect the paint of the oil pan during flushing. After applying Decarboil on engines with a painted carter, make sure the paint is intact and remove the paint yourself if necessary. If the pallet is painted on the outside, then control of the condition of the paint is mandatory. If you find swelling, cracking, partial delamination after disassembling the oil pan, be sure to remove the remaining paint. Removing the paint will allow the following flushing procedures to be performed without removing the pan.

APPLICATION

  1. Before use, withstand the composition at room temperature for 6 hours.
  2. Check the oil level and choose the correct dosage of the composition. A bottle of 100 ml is designed for 4-5 liters of oil. With a different amount of oil, the dosage is not more than 25 ml per 1 liter of oil.
  3. Warm up the engine to operating temperature, turn it off, open the oil filler.
  4. Pour the recommended dosage into old oil or new oil, flushing oil.
  5. For effective cleaning of highly contaminated engines, it is necessary to keep the engine work in the range of 1700-2300 rpm for 20-25 minutes.
  6. Switch off the engine and allow it to cool, for safely drain of used oil.
  7. After application in engines with a painted oil pan, it is necessary to verify the integrity of the paintwork, if necessary, remove the paint.
  8. Replace filter and oil.

Find nearest distributor in your country: VMPAUTO distributors network.

Sergio, your manager at VMPAUTO

Request a quote now.